Histogram Range

Where to find it:

Add Adjustment Layer / Extension Pack / Histogram /

NodeGraph / Right Mouse Click / Nodes / Filter / Extension Pack / Histogram /

Shotcut (Nodegraph Only): Shift + H

The Histogram Range Node allows you to adjust the range and position of the input histogram.

It acts like its counterpart in Substance Designer.

Video

Node Overview

Node Ports

•Range

Defines the width/range of the histogram.

If the value is over 1.0 some values might get pushed below 0.

Overwrites Range Slider if mapped

•Position

Defines the mid point position of the histogram

Overwrites Position Slider if mapped

•Mask

Optional Mask to limit the effect

Node Properties

MAIN TAB

Main

•Range

Defines the width/range of the histogram.

If the value is over 1.0 some values might get pushed below 0.

•Position

Defines the mid point position of the histogram

Clamping

•Clamp Intermediary

Clamps the internal calculation of the node to 0-1.

To understand better what this does think of the Node like a condensed Levels or Set Range Node.

The Clamp Intermediary will clamp the output of the first part of the calculation - the 'Input' Levels (on a levels node)

or 'Old Minimum' and 'Old Maximum' values (on a Set Range Node) to 0-1.

•Clamp Output

Clamps the Output of the node to a 0-1 range

Mask

•Mask Intensity

Control the intensity of the effect.

If a Mask it attached to the Mask port of the node this will control the intensity of the supplied mask